Search:
Type: Posts; User: Rip it up
Search: Search took 0.00 seconds.
-
17th February 2015, 03:53 PM
Thread: 150mm OD HDPE needed
by Rip it up- Replies
- 13
- Views
- 1,576
Oh Shiite. Good luck with that then. Custom job...
Oh Shiite. Good luck with that then. Custom job for sure.
Damo's dodgy boat building repair centre. -
17th February 2015, 12:45 AM
Thread: 150mm OD HDPE needed
by Rip it up- Replies
- 13
- Views
- 1,576
For your poly pipe search, try the local council....
For your poly pipe search, try the local council. It's a common pipe size for water mains in new estates etc. offcuts are recyclable material. And as a result sometimes turn up at the local tip as...
-
26th October 2014, 12:48 AM
Thread: New Shed build
by Rip it up- Replies
- 99
- Views
- 17,827
Any updates on this shed. Damo's dodgy boat...
Any updates on this shed.
Damo's dodgy boat building factory. -
21st September 2014, 01:04 AM
Thread: Japanese Kitchen Knife Set
by Rip it up- Replies
- 19
- Views
- 3,986
Stunning. Craftsmanship is a dying breed in...
Stunning. Craftsmanship is a dying breed in today's society.
Well done.
Damo's dodgy boat building factory. -
9th April 2013, 05:53 AM
Thread: Air compressor fittings
by Rip it up- Replies
- 11
- Views
- 2,583
Air compressor fittings
Just a small input from me.
Where you terminate the gal pipe throughout the shed most times it is run vertically. So if feed air comes from top down install a tee piece and 300mm of pipe pointing... -
27th October 2012, 03:44 PM
Thread: Boat Plans
by Rip it up- Replies
- 9
- Views
- 4,403
Boat Plans
Look at the impulse dinghy. Solo boat built from ply
-
18th April 2012, 05:11 PM
Thread: Another Project - Cherub
by Rip it up- Replies
- 4
- Views
- 2,076
Great little boats to sail. I "learnt" how to...
Great little boats to sail. I "learnt" how to sail one 15 years ago.
Hate going upwind in light winds but are good fun in 25 knots downwind.
Good luck with the project. -
17th February 2012, 05:11 PM
- Replies
- 5
- Views
- 4,746
What tool are you using to sand with? Grades of...
What tool are you using to sand with? Grades of paper etc?
I usually use a 6" pneumatic orbital with Velcro pads. Preference for 3M "hookit" discs in 80, 180, 320 grades and hand finish above...