Search:

Cheers I was planning on changing the blade. Hopefully that will fix it.

Picked up a small second hand Ryobi bandsaw but the blade seems to want to cut on an angle. I've messed about with the roller and alignment and it seems to have straightened a little.

Any tips...

Your right Mark. The Maker had no Idea. It was me. My first attempt at any real type of furniture making. Had the idea in my head and then just went at it. The legs are from 35mm Pine and Jarrah and...

Hi Rob,
Your solution sounds best so far. I saw something similar on youtube and was going to give it a try. I think I will end up starting again but have nothing to loose by trying to salvage it...

I read somewhere that that was an old tale. but starting to think not.

The MDF is 18mm and the pine, jarrah and merbau are all 19mm thick. The top and legs have 4 coats of Danish Oil and the top...

Hi Ian, Photos should be attached. I've taken the top off and flipped it on the ground and put weights on it to try and reverse the effect. It is pretty humid hear in west Australia and we run...

I've had my new table top inside the house for around 3 weeks.

I noticed something a little odd. On closer inspection the top has warped. Two corners have drop almost 30mm.

The base is mdf with...

Cheers Master Splinter, Looking forward to getting this finished.

Hi Ian, Pictures attached to original post. This was my first attempt at a serious project so the joinery will improve over time I hope.

Cheers

Hi Friends
I've just finished building a new table and oiled it. Now I'm looking to seal it. The timber has a few imperfections in it that I liked and choose not to sand out and some couldn't be....

I've been messing about in the shed for a couple of months and want to get a new TS and need advice on a good starting point. I've been using a makeshift Table Saw that I made myself but would like...