Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Sturdee Laminate/veneer Roller.
-
20th July 2004, 09:01 PM #1Deceased
- Join Date
- Jun 2003
- Location
- ...
- Posts
- 7,955
Sturdee Laminate/veneer Roller.
For some time I have been interested in getting a laminate/veneer type pushdown roller. Although I have seen them in overseas books and magazines I have been unable to find one locally.
When I was cleaning out the shed for my finishing room I found an old portable typewriter that I haven’t used for about 30 years but never thrown out (I am a hoarder too, Jackie ).
This gave me the idea of building my own using this old typewriter roller.
The roller is 240mm * 32mm diameter and after a good clean up with metho looks as good as new. At one end has a ¼ inch hole and the other end has a 5/16 size hole which allows it to be fixed to a handle with cut of coach bolts.
The first picture shows the various parts used. Dimensions are dependent on the roller used but mine has an overall size of 290 * 155 mm.
The second picture shows the cut of bolts fixed to the sides. On both sides of the timber sides I used double nuts tightened against itself and a washer.
The third picture shows the sides being glued and clamped against the handle. At this stage you have to fit the roller over the bolts before gluing. Whilst I used the worlds best glue (Garrett Wade’s 202GF) these joints will have considerable pressure on them so after the joints were dry I drilled at each side two dowel holes and glued in 8mm dowels making in effect double round through mortice and tenon joints. See picture no 4.
Picture no 5 shows the details of the way the roller is fixed to the cut of bolts , on the outside a covered the nuts with a rubber chair stopper.
Peter.
-
20th July 2004 09:01 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th July 2004, 09:05 PM #2Deceased
- Join Date
- Jun 2003
- Location
- ...
- Posts
- 7,955
Picture no 6 shows the roller ready after finishing. I gave it two coats of hard shellac and a coat of Traditional wax.
It is a real nifty tool and I already gave it a work out in veneering new edges to a coffee table I am restoring.
Similar rollers are easily obtained from old typewriters or the old dot matrix printers usually found thrown out at hard rubbish collections or available from op shops for a few dollars.
Peter.
-
20th July 2004, 09:18 PM #3
Great example of recycling Sturdee!
We had a 'hard rubbish' collection last week.
If I knew then what I know now, I would have been on the lookout for type writers and dot matrix printers.
Hooroo...
Mark.I wanted to become a brickie but my old man said "No son, learn a trade."