Need Help To Make Bowl

[alienware23]

i want to make a shallow bow in the design of the one pictured below. I can make a square bowl with four equal height tips but i want to make one with two different height tips , If anyone can help me i would be greatly appreciated. Thank you

[hughie]

i want to make a shallow bow in the design of the one pictured below. I can make a square bowl with four equal height tips but i want to make one with two different height tips , If anyone can help me i would be greatly appreciated. Thank you

[/QUOTE]

Well I reckon, you might need a band saw to get you wings done. Turn it full size and then cut the wings with a band saw, hand finish the edges, you could do a fair bit of the work with power sanding. Then do the finishing by hand.

[artme]

Exactly my thoughts, Hughie!!!

[wheelinround]

or cut the bowl on BS to shape re glue edges as sacrificial till turned the rest

[TTIT]

You could get the same shape as the glass one just by starting with a diamond shaped blank - too easy. If you don't like turning air you could always glue some waste on to the diamond

[tea lady]

Lots of carving after turning a square platter?

Another wacky idea is to turn an oval hollow vase form shaped like football. (Aussie rules type not soccer. ) and cut it off the side. Prolly get two. Don't know how to do the base though. Sand a flat bit? Or get one of those oval turning thingies.

Steam bend two corners up?

Sometimes you just gotta say "somethings can only be done in certain materials".

[Skew ChiDAMN!!]

TTiT's way is the "traditional" method of doing it.

The way to tell if a piece has been made this way, is to to look down at it from overhead. If the edges form straight lines, then

There's absolutely nothing stopping you from turning a round bowl and then marking/cutting the edge to shape you want with a BS or fretsaw. You can then make the curve such that the edge doesn't form a straight line no matter how it's viewed. It's more difficult to mark out this way, of course, and wastes more wood; you need to start with a larger blank, whereas TTiTs method uses sacrificial waste.