Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Hercus Mill Dividing Plates
-
20th February 2011, 01:53 PM #1GOLD MEMBER
- Join Date
- Jun 2007
- Location
- sydney
- Age
- 64
- Posts
- 3,566
Hercus Mill Dividing Plates
I am thinking about making some Dividing plates,would there be any interest in these.
They could either be the standard size or holes could be made to suit.
The standards diameter is 3," plates could extend to roughly 3 1'2" and still clear the steady clamp , if a larger plate was used you would need to increase the length of the sector arms,not a big job you would still retain the originals with etensions attached to the arm to accomadate a larger OD.
-
20th February 2011 01:53 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
Similar Threads
-
Hercus Dividing Head - Division Plate
By Anorak Bob in forum THE HERCUS AREAReplies: 16Last Post: 25th February 2011, 11:27 AM -
Question on Vertex dividing plates
By Jekyll and Hyde in forum METALWORK FORUMReplies: 15Last Post: 8th January 2011, 03:49 PM -
Hercus Dividing Head
By Anorak Bob in forum METALWORK FORUMReplies: 9Last Post: 3rd January 2011, 09:20 PM -
Hercus Back Plates
By pipeclay in forum THE HERCUS AREAReplies: 7Last Post: 14th September 2010, 09:23 PM