Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Nova Insert stuck in!!!
-
7th July 2011, 04:15 PM #1
Nova Insert stuck in!!!
Hi,
I need to know how to get an insert out of a Nova chuck that is stuck in. I have tried to unscrew it. It is really in. Any ideas??
Regards BenRegards Ben
-
7th July 2011 04:15 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
7th July 2011, 04:51 PM #2
Ben check you have undone the grub screw for starters.
Are you turning the right way
how are you holding and turning it?
The grub screw may have damaged some thread if over tightened and squashed it, then its
-
7th July 2011, 05:32 PM #3GOLD MEMBER
- Join Date
- Jun 2006
- Location
- Burwood NSW
- Age
- 82
- Posts
- 1,247
After checking as Wheelinround said ,Clamp a bit of wood crosswise in the jaws then place the chuck jaw side down on a solid surface so's it is resting on the bit of wood and not the face of the jaws .Place a bit of hardwood on top of the insert and give it a solid wack with a hammer and that should loosen it . I had this problem with a vimarc chuck a while ago .It may also pay to try and run some penatrating oil into the thread .
Ted
-
7th July 2011, 05:35 PM #4
So Tight.
Hi Bupton,
Yes As Wheelin said, + use some Loctite, Freeze & Release or Inox from both inside & out & leave for awhile.
Put the Insert in the vice, open the Jaws just enough to use a longish piece of steel across the Jaws & pull on that.
Other than that, you may have to use heat .Regards,
issatree.
Have Lathe, Wood Travel.
-
7th July 2011, 05:38 PM #5
So Tight Again.
Ted was writing at the same time that I was, so now you have 2 ways.
Regards,
issatree.
Have Lathe, Wood Travel.
-
7th July 2011, 08:07 PM #6
Hi,
Thanks, I have fixed the problem with the jaws out and a bar in.Regards Ben
-
7th July 2011, 10:25 PM #7
"If at first you don't succeed, get a bigger hammer!"
Similar Threads
-
Chuck insert stuck
By turnerted in forum WOODTURNING - GENERALReplies: 13Last Post: 11th January 2010, 08:59 PM -
Help! My Triton collet is stuck, and it's not the typical stuck collet!
By old750 in forum TRITON / GMCReplies: 1Last Post: 1st November 2009, 10:03 PM -
Stuck box
By Tiger in forum WOODTURNING - GENERALReplies: 9Last Post: 10th June 2009, 02:56 PM -
Positioning router on insert, installing insert
By Johncs in forum ROUTING FORUMReplies: 4Last Post: 26th March 2009, 09:20 PM -
HELP!!!!! I'm STUCK!!!!!!!
By ElizaLeahy in forum WOODTURNING - GENERALReplies: 10Last Post: 26th January 2009, 10:53 PM