Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Align A Rip Fence modification
-
12th May 2005, 06:59 PM #1
Align A Rip Fence modification
Greetings all, just got an Align A Rip fence and am a bit annoyed that none for my previouly made T-Track toys fit on to the fence.
A quick way out would be to screw a legth of T-Track along top of the fence. This would at least allow me to use some of the hold downs and stops from my router table and drill press.
Or maybe I shouldn't be so tight and buy some fittings that suite the fence.
Has anyone experimented with this type of modification?
Suggestions????????????????
Thanks
Chris.
-
12th May 2005 06:59 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
12th May 2005, 07:15 PM #2
Which one/model is it, cause mine has a t slot along the top and on the sides.
Bruce C.
catchy catchphrase needed here, apply in writing to the above .
-
12th May 2005, 08:44 PM #3
The fence has no model number on it but the manual says FB3-2.
There is a track on either side, it it is a smaller profile than the T-Track. There is no track on the top.
Thanks
-
21st May 2005, 02:46 AM #4
A Zenith 1/4" octaginal shaped nut fits in perfectly!
....................................................................
-
21st May 2005, 09:23 PM #5
Thanks Harry,
I have decided that the table saw can have its own bits and pieces. I did want to be able to swap between router, drill and saw. Oh well just have to make more toys.Specializing in O positive timber stains