Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
21st February 2015, 05:13 PM #1New Member
- Join Date
- Sep 2013
- Location
- Queensland
- Posts
- 1
Variable Frequency Drive settings I need need help!!!!
I have recently purchased a 6040 800w water cooled cnc router off ebay. I have set it all up following the very sketchy instructions and have tested it and I was very happy with the results. The next time I went to use it I have accidently pressed one of the buttons on the VFD Inverter and have somehow changed all of the settings so now when I push the green run button the spindle does not start . If I press the set button the led displays pn01 and if I keep scrolling through it goes up to pn35. The instruction manual tells me no more than how to adjust the spindle speed using the speed control knob. I have tried looking on the internet for a manual but because there is no brand name on the VFD I haven't had much luck The VFD is 220V 1.5KW Spindle is 800W 220V 400HZ 24000RPM water cooledI have also attached a photo of the VFD I hope someone can help me with this little problem as I am looking forward to using my cnc router again.
-
21st February 2015 05:13 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
22nd February 2015, 07:21 AM #2Saw dust maker!
- Join Date
- Sep 2006
- Location
- Wandong
- Age
- 60
- Posts
- 453
-
22nd February 2015, 07:21 AM #3Member
- Join Date
- Jan 2012
- Location
- Springfield Lakes
- Posts
- 60
VFD Settings
Check this out.
https://www.woodworkforums.com/f170/tips-newbie-huanyang-vfd-users-96380
It has a lot of info but the first few pages are very helpful.
good luck
-
31st March 2015, 11:58 AM #4
you get it sorted?
Similar Threads
-
Variable Frequency drive inverter
By woodfast in forum METALWORK FORUMReplies: 6Last Post: 15th September 2014, 08:56 AM -
Variable Frequency Drive Problem
By stevew in forum WOODTURNING - GENERALReplies: 10Last Post: 14th May 2011, 10:10 PM -
Variable frequency Drive Confusion
By Fossil in forum WOODTURNING - GENERALReplies: 13Last Post: 29th July 2006, 04:49 PM