Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
-
18th October 2005, 01:04 PM #1Senior Member
- Join Date
- Jan 2005
- Location
- Snowtown South Australia
- Age
- 78
- Posts
- 321
Delta chisel morticer fence adjustment.14-651
How can i adjust the fence on a Delta chisel morticer? I can move the fence in and out without problems,but there is a 2 to 3 mil runout from the fence to the edge of the base running left to right.The model number is 14-651.Has anyone else experienced this problem? Regards...........AL
If your not confused you dont know whats going on!
-
18th October 2005 01:04 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
18th October 2005, 01:48 PM #2Originally Posted by 46150
I do not think there is any specific adjustment for the fence other than in and out.
If the fence is not square to the chisel, you may be able to get some adjustment by loosening the four screws at the base of the column. Alternatively you may be able to get some adjustment by loosening the screw that attaches the rack to the fence.
Growing old is much better than the alternative!
-
18th October 2005, 02:24 PM #3Senior Member
- Join Date
- Jan 2005
- Location
- Snowtown South Australia
- Age
- 78
- Posts
- 321
Thanks for that Sprog.I'll go over to the shed this arvo and have another play.What you say is probably right.If the fence and the side of the drill are parralell,then the job should be right,any other info would be appreciated,Regards..................AL
If your not confused you dont know whats going on!
-
18th October 2005, 04:05 PM #4
Yep he's right Al, it doesnt really matter. Did your machine come with the riser block?
....................................................................
-
18th October 2005, 07:58 PM #5Senior Member
- Join Date
- Jan 2005
- Location
- Snowtown South Australia
- Age
- 78
- Posts
- 321
Yea,g'day Harry,The riser block came with the machine.At this stage i hav'nt used it,but will give it a go tomorrow.The machine was assembled at MIK when i bought it so have to go through the instructions to really get the hang of it.Have you done the 180 degree thing yet?After i posted this i noticed you had a post along the lines we are now talking about in Feb 2005.That helped a bit.Anyhow,thanks all for your input.Regards...............AL PS,had any rain,Harry???
Last edited by 46150; 18th October 2005 at 08:00 PM. Reason: Forgot!
If your not confused you dont know whats going on!
-
18th October 2005, 11:19 PM #6
Nah havent turned the table 180° yet, but have added the riser block... you lose the fence adjusting set up tho not that its needed!
Yep she's been pissin down all day here....................................................................
Similar Threads
-
Wood Chisel Survey for Beginners
By Bob Smalser in forum HAND TOOLS - UNPOWEREDReplies: 16Last Post: 11th April 2020, 05:03 AM -
Delta hollow morticer
By Harry72 in forum HAND TOOLS - POWEREDReplies: 15Last Post: 17th March 2005, 01:40 AM