Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
24th March 2008, 03:10 PM #1
OZ and Goat and Storer style rudderbox - avoid breakages
Howdy All,
Good little story here.
Got this email from Jonathan Bornman whose sons have been building two OZ PDRs in Africa.
They went sailing for the first time and used the "wrap sail around mast" reefing method I used after my PDR speed record attempt. While I wouldn't be planning to get upwind under such a rig - returning home on a reach or a run seems to work quite OK.
HOWEVER - they broke their rudderboxes.
This is Jonathan's email
Hello Michael,
Here are few shots of our first attempts at sailing our just completed PDRacers. There was a stiff wind. We had fun but we also ran into problems with the rudders. The this 4mm plywood sides failed almost immediately on the first two we put in the water. The third boat never went got tested. I am sending you a picture. I would welcome your thoughts.
Thanks for a great set of plans! They were easy to follow.
Hi Jonathan,
Very exciting to hear the boats are in the water.
With the rudders - all the bolts need to be in place as in the drawings. The boxes are weak without them and almost indestructible with them.
None of this is really my doing - the design process was carried out over thousands of OZ and NZ racing boats where this method is still quite dominant. I saw it first on Paper Tiger catamarans in 1973 - and realised its importance as a 12 year old. I've used it on a succession of boats and slowly realised exactly what you have to do to make it light, simple but incredibly reliable.
With our original boats we did not use manufactured rudder fittings either but put lots of fibreglass tape around the front edges of our wooden rudder fittings that went back onto the rudder box.
The glass tape is entirely unnecessary if you use the fittings in the plan drawings.- shown below. This drawing is actually a little inaccurate as there needs to be a bolt through the tiller - not shown in this drawing, though one in the plan body does show it.
You can see the pictures here of the glass taping - it was quite heavy with about 5 or 6 layers of tape built up wet on wet.
However some bolts and washers in the same places as the specified rudder fittings will do a good job too.
Here I think is the problem ... there is lots of glass tape in the finished pic below - but you cannot see it at all.
The rudder boxes are a really good design are super reliable and completely trouble free - they work brilliantly in every conceivable condition. Please be prepared to perservere with getting them right as they are the best solution for almost every boat.
Best wishes
Michael
Also thanks for the photo of the failure which makes this larger article a bit possible.
Thanks again
Michael
-
24th March 2008 03:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
Similar Threads
-
To avoid intoxication
By echnidna in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 5Last Post: 14th June 2007, 08:14 PM -
What biscuits to buy /avoid?
By occam in forum HAND TOOLS - POWEREDReplies: 14Last Post: 18th July 2006, 12:20 PM -
What gets up my goat!
By Waldo in forum HAVE YOUR SAYReplies: 27Last Post: 12th August 2005, 12:43 AM -
How to avoid burn marks
By youvee in forum ROUTING FORUMReplies: 3Last Post: 24th January 2004, 01:21 PM