Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: No 1 Morse Taper Drive Spur
-
4th August 2008, 05:44 PM #1Member
- Join Date
- Apr 2006
- Location
- Newcastle
- Posts
- 91
No 1 Morse Taper Drive Spur
Could someone help me with a Number 1 drive spur ,I am going to slip it into a no 2 reducer so I can use it in the lathe without constantly removing the Vicmarc chuck.
With pay postage and handling.Look forward to some advice or replies.
Thank you.
Steve
-
4th August 2008 05:44 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
4th August 2008, 11:29 PM #2
Why not give a Steb-style drive centre a try or just cut a groove at the top of the taper of your current drive. The Vicmark jaws grab the drive in the groove perfectly so you don't have to take the chuck off at all - - - - - - - - - until you get another chuck - - - - - - - - - and vacuum chucks - - - - - - - - and another chuck - - - - - - -
I've only got 3 - Cliff's the man!
-
5th August 2008, 05:47 PM #3Hewer of wood
- Join Date
- Jan 2002
- Location
- Melbourne, Aus.
- Age
- 71
- Posts
- 12,746
Or: Teknatool make a small drive spur that fits their chucks ... might be worth asking how they'd go in VM chucks.
http://www.teknatool.com/products/Ch...SpurCenter.htmCheers, Ern
-
5th August 2008, 06:10 PM #4
They do fit on the VM chucks just not as much coverage in the ring part as the nova chucks.
Will do the job as long as it was not a big heavy peice.Jim Carroll
One Good Turn Deserves Another. CWS, Vicmarc, Robert Sorby, Woodcut, Tormek, Woodfast
Are you a registered member? Why not? click here to register. It's free and only takes 37 seconds!
Similar Threads
-
Morse taper 2 & 3 arbor dwgs
By neksmerj in forum METALWORK FORUMReplies: 1Last Post: 11th May 2008, 07:52 AM -
Releasing morse taper
By jvdv in forum METALWORK FORUMReplies: 9Last Post: 24th October 2007, 04:01 PM -
Morse Taper Turning
By jvdv in forum METALWORK FORUMReplies: 46Last Post: 13th September 2006, 03:26 PM -
Morse Taper problem
By graemet in forum HAND TOOLS - POWEREDReplies: 26Last Post: 15th June 2006, 09:18 PM -
No morse taper
By esiegel in forum WOODTURNING - GENERALReplies: 13Last Post: 16th June 2004, 11:20 PM