Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Tap & die, wanted to borrow.
-
26th March 2009, 12:07 AM #1Product designer retired
- Join Date
- Nov 2006
- Location
- Heidelberg, Victoria
- Age
- 79
- Posts
- 2,251
Tap & die, wanted to borrow.
If this request is in the wrong place, my apologies.
I need to repair a part on my old Singer boot patcher, and need to retap a threaded hole.
As best as I can measure, the mating screw is No.6x40 UNF with an ID of approx. 0.14".
If a kind member could lend me a bottoming tap and die, I would be pleased to hear from you.
Would only need tap and die for 5 minutes and can't justify buying them for a one off job.
I'm in Heidelberg, Melbourne.
Ken
-
26th March 2009 12:07 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
26th March 2009, 10:43 PM #2Senior Member
- Join Date
- Mar 2009
- Location
- Blue Mountains
- Posts
- 175
Singer threads
Hello Ken,
you might have a lot of trouble trying to get a tap for Singer products as they used non standard threads. The tpi will be a common number but the thread outside diameter will not match with any standard thread series. A Singer repair agent who has been around a long time might be your best bet as he might have the correct taps for his own repairs.
Phillip.
-
26th March 2009, 11:33 PM #3Product designer retired
- Join Date
- Nov 2006
- Location
- Heidelberg, Victoria
- Age
- 79
- Posts
- 2,251
Hi Phil,
I appreciate your advice, and can only hope it is a standard size thread. I guess I'll only find out when I can borrow a die and tap. Finding an old Singer mechanic for industrial machines, may be more difficult than milking a cow with a spanner.
Ken
-
27th March 2009, 06:43 PM #4
When I worked in the Special School, we had a Singer Industrial of 40's to 50's vintage which was serviced by a guy in Heidelberg Road around the Ivanhoe shooping strip area. Sorry I can't be more specific but it might be worth a small time in hunting.
-
27th March 2009, 07:58 PM #5Product designer retired
- Join Date
- Nov 2006
- Location
- Heidelberg, Victoria
- Age
- 79
- Posts
- 2,251
Hi Malb, it would be great to hunt down this service guy you mentioned. Any more info?
In the mean time, I no longer need to borrow a die and tap. The job is done and dusted. I managed to purchase the last tap on the shelf, from North East Industrial for a low cost.
No.6x40 UNF was the correct size.
I appreciate the help I've received.
Ken
Similar Threads
-
Can I borrow a Sierra kit ??
By arose62 in forum SWAP, BARTER, SUPPORT A WORTHY CAUSEReplies: 21Last Post: 19th December 2007, 09:44 AM -
Always wanted one.....
By MurrayD99 in forum HAND TOOLS - POWEREDReplies: 10Last Post: 21st August 2007, 11:34 AM -
Help Wanted
By QbnDusty in forum WOODTURNING - GENERALReplies: 4Last Post: 15th April 2005, 11:12 PM -
Borrow someone's drill press?
By John G in forum GENERAL & SMALL MACHINERYReplies: 5Last Post: 30th December 2003, 09:39 PM