Search:

Tag: inlets

Search: Search took 0.00 seconds.

  1. 4" Cyclonic - Just made one

    Started by seafurymike, 5th March 2014 10:35 AM
    $600+, 306463306464306465, attempt, cyclonic, decided, deputies, domed, dust, figures, finished, form, inlets, learnt, lips, load, metal, months, night, oneida, school, shrinking, stretching, sucker, tested, time, tops, trade, units 6 Attachment(s)
    • Replies: 7
    • Views: 1,677
    Last Post: 5th March 2014 10:44 PM
    by RayG  Go to last post

    Forum:
    METALWORK FORUM

  2. Alternative Dust Extraction Solution

    Started by mick59wests, 22nd October 2013 01:49 PM
    8 Pages •
    1 2 3 4 5 6 7 8
    100mm, 2300, 240v, air, alternative, bag, cfm, clearvue, collectors, dc-7, dust, equipment, extraction, filter, fine, impeller, inlets, low, lphv, machine, motor, power, pressure, real, single, solution, system, volume, w329, wood 6 Attachment(s)
    • Replies: 115
    • Views: 12,241
    Last Post: 25th November 2013 08:20 PM
    by mick59wests  Go to last post

    Forum:
    DUST EXTRACTION

  3. Real DC flow versus Manufacturers specifications

    Started by BobL, 25th May 2013 01:48 PM
    1200, 1250, 1hp, 2200, 2hp, 350, 3hp, 600, 650, cfm, claims, dcs, difference, explain, factor, flow, inlet, inlets, manufacturers, measure, performed, produced, rating, real, restricted, specifications, test, tests, typical, versus
    • Replies: 8
    • Views: 1,686
    Last Post: 27th May 2013 09:59 PM
    by BobL  Go to last post

    Forum:
    DUST EXTRACTION

  4. Dust Extraction setup question

    Started by groeneaj, 8th May 2010 08:54 PM
    1200w, 240v, 2hp, andy2tsup, blastgate, bosch, compared, cyclone, dust, dusty, exceed, extraction, gts10, hey, hose, hoses, initially, inlets, junction-, karcher, metres, port, question, results, setup, shop, sound, table, underneath, vac
    • Replies: 9
    • Views: 2,164
    Last Post: 23rd May 2010 06:14 PM
    by groeneaj  Go to last post

    Forum:
    DUST EXTRACTION

  5. Ducted Vacuum setup: SCMS

    Started by groeneaj, 7th May 2010 06:34 PM
    andy2tsup, attached, cap, cyclone, ducted, hose, house, inlets, installed, linisher, moved, pics, run, scms, serious, setup, shop, suck2tsup, vacuum, vacuuming
    • Replies: 0
    • Views: 1,754
    Last Post: 7th May 2010 06:34 PM
    by groeneaj  Go to last post

    Forum:
    DUST EXTRACTION

  6. A plumber left a big hole in the wall behind our new vanity

    Started by Reno RSS Feed, 9th October 2009 03:20 PM
    basin, cabinet, cockroaches, cut, finished, hole, house, inlets, job, left, mice, plaster, plumber, re-arrange, read, renovateforum.com, sealed, thread, vanity, wall, water
    • Replies: 0
    • Views: 1,705
    Last Post: 9th October 2009 03:20 PM
    by Reno RSS Feed  Go to last post

    Forum:
    RENOVATE FORUM RSS FEED

  7. Wood heater smells

    Started by Smurf, 28th April 2008 12:44 AM
    adjusted, adjusting, air, bottom, closed, cold, coming, controls, door, earlier, encountered, fire, flue, half, heater, inlets, lot, proper, relative, remember, saxon, shut, slower, smell, smells, smoke, started, top, wondering, wood
    • Replies: 10
    • Views: 6,800
    Last Post: 30th April 2008 12:49 PM
    by SilentButDeadly  Go to last post

    Forum:
    HEATING & COOLING

  8. Convert separate cold/hot shower to single level type

    Started by Ashwood, 23rd April 2008 09:41 AM
    acts, cold, cold or hot, cold/hot, control, convert, converts, feedback, handyman, hot, inlets, level, lever, mag, product, separate, shower, single, takes, tap, taps, type, water, wondering
    • Replies: 5
    • Views: 4,911
    Last Post: 29th April 2008 02:23 PM
    by Bloss  Go to last post

    Forum:
    PLUMBING

  9. Connecting two 90mm tank overflows into 100mm stormwater

    Started by Bags, 15th April 2008 01:35 PM
    100mm, 4000g, 90mm, backup, connecting, delivered, inlets, match, metre, overflows, pipe, pipes, planning, prevent, run, run-off, separate, size, storm, stormwater, sufficient, tank, water
    • Replies: 2
    • Views: 3,458
    Last Post: 15th April 2008 08:29 PM
    by davo2310  Go to last post

    Forum:
    PLUMBING, ELECTRICAL, HEATING, COOLING, etc

  10. Festool Rotex 150-slight electrical shocks

    Started by jimj, 30th March 2008 02:58 PM
    2 Pages •
    1 2
    125, 150, 150slight, air, arm, box, design, electric, electrical, fault, festool, flows, handle, hard, inlets, intake, noticed, plugged, rant, rotex, safety, sander, shocks, slots, sweat, tingle, top, vents, wet, wondering
    • Replies: 18
    • Views: 3,494
    Last Post: 2nd April 2008 02:10 PM
    by Vernonv  Go to last post

    Forum:
    FESTOOL FORUM

  11. Sealing gas inlets on wok burner

    Started by R. McCarthy, 11th December 2007 12:02 PM
    2 Pages •
    1 2
    100%, answer, apparently, appreciated, bbq, burner, cap, conjunction, experts, fish, gas, guarantee, ideas, inlets, kettle, mccarthy, mounted, pipe, plumber, ross, safely, seal, sealing, specialist, sydney, tape, tells, unit, wok
    • Replies: 16
    • Views: 2,869
    Last Post: 18th January 2008 09:08 AM
    by R. McCarthy  Go to last post

    Forum:
    METALWORK FORUM

Results 1 to 11 of 12