Help with Boring bit grinding

[Retromilling]

Can anyone please give me a sketch or photos of the correct way to grind a boring bar HSS tool bit.
I have a bit working with a relief angle on the front cutting face and two angles on the end to give relief away from the job wall in the two directions . However I am unsure if I have got the best geometry.

[Dave J]

Retromilling I have sent you a email.
Dave

[Dave J]

I had another member PM me asking for the info that I had sent Retromilling.I am sorry about not putting it up here, as I thought it was to big of a file to put on the forum, I have looked it up on the internet and have found the link to it, as I only had it on my computer as a file.
http://www.cutterod.com/cutter_zone/General/How_To_Grind_Lathe_Tools.pdf
Hope this helps out Dave

[Retromilling]

Thanks Dave . The grind is the same as a lefthand tool . Mine is similar but not exactly right.