View Full Version : WOODWORKING QUIZ for 27 AUG 04
Ralph Jones
27th August 2004, 09:34 PM
Good Evening Friends,
Routing an edge profile on delicate workpieces can cause bad tearout and even ruin a valuable piece.
What can you do to eliminate this from happening?
Respectfully,
fxst
27th August 2004, 10:01 PM
pay a professional.................
or again with the right currency(reds etc) call on termite ......profiles chewed while u wait
Pete
journeyman Mick
27th August 2004, 10:14 PM
Use a moulding plane of course!
Derek Cohen :D :eek: (Mick ;) )
RETIRED
27th August 2004, 10:26 PM
Better yet Mick. Send it to Derek and let him do it. :D
Ralph Jones
28th August 2004, 09:38 PM
Good Evening Friends,
I head off this problem by using a technique borrowed from ripping plywood, where a scoring blade is sometimes used.
Before I even plug in the router I scribe a line along the workpiece edge, scoring the material at the height to match the bit. A marking gauge fitted with a steel cutter rather than the pin, makes the scoring task easier.
Respectfully,
echnidna
28th August 2004, 09:58 PM
Though if you are using a power feeder a simple climb cut does the job.