wheelinround
13th April 2010, 10:29 PM
Question:
Do you get tired of always having to reset the tool rest height every time you loosen the lock?
Try this. Place a hose clip (like on car heater hoses) to the tool post at the desired setting and tighten. This is handy for when you are turning the outside of the a bowl.
Robbos Tip of the Week (http://quiz-art.com/all-woodwork-art/quiz-17311.html)
All about Symtec Lathes
ADDED
Original page located here (http://www.woodworkforums.com/f8/robbos-tip-week-38/).
Please see post 7 (http://www.woodworkforums.com/f8/historical-robbos-tip-week-116261/#post1139194) :aro-d: for explanation
.
Do you get tired of always having to reset the tool rest height every time you loosen the lock?
Try this. Place a hose clip (like on car heater hoses) to the tool post at the desired setting and tighten. This is handy for when you are turning the outside of the a bowl.
Robbos Tip of the Week (http://quiz-art.com/all-woodwork-art/quiz-17311.html)
All about Symtec Lathes
ADDED
Original page located here (http://www.woodworkforums.com/f8/robbos-tip-week-38/).
Please see post 7 (http://www.woodworkforums.com/f8/historical-robbos-tip-week-116261/#post1139194) :aro-d: for explanation
.