can some one make this for me???

[nz_carver]

Hey all im about to move to a bigger work shop
and have been wanting a new bench

now as i carve and turn my workshop is not setup to make things like this

I had someone set to make me the benchlike he one in the pic but after w8ing months Im passing it on to anyone that can make it

this is a pic of one i found on ebay
Now most of you will be thinking why not just get it from there
well here is the thing I dont just wana click buy nowand have all the hard work done for me I wana help make it:2tsup:

so if ypu think you have the time to help im happy to pay for time and stuff to get it done

2400mm (L) x 600mm (D) x 1000mm (H)

thanks nz_carver:2tsup:

[Travis Edwards]

as no one else has bothered to reply I will. I reckon you should be able to build that plenty easy enough all you need for that is a drill, some flooring, and a bit of 90 by 45 pine, But I reckon you could build a better one!!! Get some wide kd hardwood boards for the top use two boards for each leg at right angles to each other. I would set the shelf lower so that you can put a foot up on it while you are working and allow the top boards to over hang the frame by 75 to 80 mm so you have something to clamp to.

[ficfac]

still looking?