Setting up Power Feeder on ripsaw

[echnidna]

I need to produce 2mm thick strips repetitively so am considering setting up my power feeder on my sawbench.

I may have to leave the centre wheel out when doing this as I don't want it to foul on the saw blade.

I will need to make a new fence that will allow the wheels to contact the edge of the timber. A hardwood fence that attaches to my existing fence is probably the easiest one to make.

Any tips??

[StockyLil'Ozzy]

sounds like you might be cutting HCV,s (hand cut veneers). Glen Holst is concidered a master ( something to do with a churchill scholarship ). Hes in the south west town Bridgetown. check out his stuff ond his website dunno address