Iain
31st October 2004, 10:46 AM
Print off the pattern onto A4 and fold the pattern on the line onto a piece of 2x1 pine (or whatever scraps are around).
Wrap masking tape around either end to hold the piece together when cut and commence with the top cut then the side cut.
You now have a 3D cut out that needs to be Dremelled (?) or hand sanded.
Seal and paint. Enjoy.
Wrap masking tape around either end to hold the piece together when cut and commence with the top cut then the side cut.
You now have a 3D cut out that needs to be Dremelled (?) or hand sanded.
Seal and paint. Enjoy.