wheelinround
18th November 2010, 05:48 PM
I am fitting some plain metal draw slides to tool cabinet draws.
I am wondering how high to raise the 1st one up from the base.
Reading the instructions it says "to tip the draw to a 30 deg angle and then slide it in" once fitted but there is no mention of positioning. No mention of clearance.
I was considering raising it maybe 5mm off the base would that be enough.?
Ray
I am wondering how high to raise the 1st one up from the base.
Reading the instructions it says "to tip the draw to a 30 deg angle and then slide it in" once fitted but there is no mention of positioning. No mention of clearance.
I was considering raising it maybe 5mm off the base would that be enough.?
Ray