smidsy
10th November 2004, 07:07 PM
Went up to Carbatec today to get a Vicmarc screwplate - I figure I can use it with the clone chuck until I get a Vicmarc.
I had only seen this beast in the catalogue but was buying it based on the Vicmarc rep.
Damn it's a solid but of kit - a nice thick plate and a screw that leaves the clone for dead in size, quality and thread.
If the Vicmarc chuck is like that I'm drooling already.
Cheers
Paul
I had only seen this beast in the catalogue but was buying it based on the Vicmarc rep.
Damn it's a solid but of kit - a nice thick plate and a screw that leaves the clone for dead in size, quality and thread.
If the Vicmarc chuck is like that I'm drooling already.
Cheers
Paul