RossM
27th December 2010, 05:08 PM
Hi All
I posted this question in "General & Small Machinery (http://www.woodworkforums.com/f155/mcjing-keyless-chuck-128936/)" forum, but then thought that this section might havew been a better place, so apologies for the double post.
Has anyone bought a keyless chuck from McJing & measured the runout? I would be keen to hear any feedback on the J0116H (http://www.mcjing.com.au/categorybrowser.aspx?categoryid=36)(0.2mm - 16mm B18)
Their website states precision as .12, which I'm assuming is 0.12mm, or approx 5 thou'
Otherwise, any suggestions on a precision chuck for a drill press (MT2)??
The spindle runout on my H&F press is quite tolerable, but the included Jacobson style chuck could be way better.
I posted this question in "General & Small Machinery (http://www.woodworkforums.com/f155/mcjing-keyless-chuck-128936/)" forum, but then thought that this section might havew been a better place, so apologies for the double post.
Has anyone bought a keyless chuck from McJing & measured the runout? I would be keen to hear any feedback on the J0116H (http://www.mcjing.com.au/categorybrowser.aspx?categoryid=36)(0.2mm - 16mm B18)
Their website states precision as .12, which I'm assuming is 0.12mm, or approx 5 thou'
Otherwise, any suggestions on a precision chuck for a drill press (MT2)??
The spindle runout on my H&F press is quite tolerable, but the included Jacobson style chuck could be way better.