Paddy
2nd September 2011, 03:55 PM
The drive belt on the lathe needs to be replaced and am not sure as to the recommended method of extracting the shaft (part way only).
Have found a manual for the CL3 , but it has a bronze bearing not a roller bearing as on the CL5.It appears that the shaft should pull out forewards and that the thread for the chuck could be used to pull it out.
However would like to know correct approach.
Does anyone have one of these?
Have found a manual for the CL3 , but it has a bronze bearing not a roller bearing as on the CL5.It appears that the shaft should pull out forewards and that the thread for the chuck could be used to pull it out.
However would like to know correct approach.
Does anyone have one of these?