_AL_
20th September 2011, 09:54 PM
Hi all, I'm an ex panel beater with many years of MIG welding experience but minimal time on a TIG. I've been out of the trade for a while now but still keep my eye in every now & again on steel.
I've finally gained permission to buy a TIG for the home garage & at this point I'm leaning towards one of these based on feedback on this site.
Welding AC DC Tig inverter welder 200 amp tig welding machine tig welders Alupulse including foot control and gas regulator (http://www.tokentools.com.au/prod18.htm)
200 amp AC/DC with a foot pedal & reg for $1600.
It'll be mainly used for light alloy work, 5mm & under & primarily for work on the tinny (boat).
Does anyone have any current feedback on these, any concerns, any suggestions etc before I cough up the money?
Thanks.
Al
I've finally gained permission to buy a TIG for the home garage & at this point I'm leaning towards one of these based on feedback on this site.
Welding AC DC Tig inverter welder 200 amp tig welding machine tig welders Alupulse including foot control and gas regulator (http://www.tokentools.com.au/prod18.htm)
200 amp AC/DC with a foot pedal & reg for $1600.
It'll be mainly used for light alloy work, 5mm & under & primarily for work on the tinny (boat).
Does anyone have any current feedback on these, any concerns, any suggestions etc before I cough up the money?
Thanks.
Al