vk4
5th October 2011, 03:09 PM
VM 100 CHUCK
I have found my problem (refer MC900 off center), I took the VM100 Check down to VERMEC this morning, as I was still having issues with turnings out of center.:rolleyes::rolleyes::rolleyes:
Collin at VERMEC and he checked it on their LATHE and confirmed that there was an issue.:rolleyes::rolleyes:
Vermec checked the CHUCK, and replaced the back JAWS, and returned the chuck all in 3 hours, talk about service.
Yes there is still some runout, but nothing like there was , and I am now very happy.:2tsup::2tsup:
Jeff
I have found my problem (refer MC900 off center), I took the VM100 Check down to VERMEC this morning, as I was still having issues with turnings out of center.:rolleyes::rolleyes::rolleyes:
Collin at VERMEC and he checked it on their LATHE and confirmed that there was an issue.:rolleyes::rolleyes:
Vermec checked the CHUCK, and replaced the back JAWS, and returned the chuck all in 3 hours, talk about service.
Yes there is still some runout, but nothing like there was , and I am now very happy.:2tsup::2tsup:
Jeff