View Full Version : Compound Drill vice
wheelinround
10th October 2011, 04:57 PM
I am trying to remove the bottom nut from this vice, I can't see a lock screw or thread have tried tapping it out but not movement as yet.
Has anyone pulled one apart and removed the bottom slide completely ??
https://images.machineryhouse.com.au/V120/0/700
Dave J
10th October 2011, 05:03 PM
I worked on one of these a few months back for the grandfathers home made lathe, but can't remember the nut. Do you have a picture of the problem nut?
Dave
wheelinround
10th October 2011, 05:07 PM
Dave its the one which allows the bottom screw to operate the first slide under the bottom.
I want to remove the slide and its stopping me from doing so:roll:
Have rung H&F's they are looking into it also.
Dave J
10th October 2011, 05:14 PM
Have you tried removing the screw to remove the slide? I am not sure but it the nut maybe cast into it.
Dave
Edit
You would also have to remove the gib
wheelinround
10th October 2011, 05:19 PM
Dave everything is off except the slide.
Just found message left on phone from George at H&F's says I must have a tight one as ones on the shelf are loose and retained in via the screw. So try tapping a little harder and its should come out. Will give it a go tomorrow. Thanks for your input Dave :2tsup: