Dengue
19th October 2011, 10:55 AM
Can anyone please advise where I might get a replacement 1/2inch comb for the Carbatec dovetail jig as seen here (http://www.carbatec.com.au/carba-tec-professional-blind-dovetail-jig_c10910) ? Carbatec want $60+ for one
The mounting hole centres are 40mm and 405mm
damian
19th October 2011, 11:39 AM
If you can get one as a pattern have you considered making one ? All it'd take is a straight bit and bearing ?
The Bleeder
19th October 2011, 11:52 AM
Jill,
Try Gregory Machinery. They also sell the same ones.
Dengue
19th October 2011, 03:10 PM
Thanks Steve. Could not find it on their website, so rang. Had to ring twice, kept dropping out after a long wait for a "Salesman". Gave up in the end. Pretty poor service
pal
20th October 2011, 12:47 PM
Jill Try Timbecon, Product Search (http://www.timbecon.com.au/productsearch/default.aspx?txtSearchBox=dovetail+jig)
Their's are a Torquata but the holes are 400 X 40.
Regards
Harold