View Full Version : Viewer Scope ..gimmick or not ?
morrisman
29th January 2012, 08:55 PM
This guy wants your money for his software . But is it a useful device ?
http://www.miketreth.mistral.co.uk/centrecam.htm
MIKE
.RC.
29th January 2012, 09:08 PM
I am sure there are free versions of that out there... I think I can remember Evan on HSM talking about it...
jhovel
29th January 2012, 09:17 PM
I've dowloaded the trial version to try with my webcam. Looks pretty useful to me. I haven't tried it on the mill yet, but could imagine it's worth the relatively small fee.
By the way, PM Harty69 and ask him about his version of something just like this.... ;)
Joe
steran50
29th January 2012, 10:02 PM
HI:),
It does look useful, how much is it anyway ?. An Idea I had the other Day for use as an Alignment Tool in a Mill / Drill Press was using a Laser Bore Sighter the Type that are used to aid in Scope Alignment on Rifles. The Idea was to use them to Align Punch Marks and Scribe Marks on the Work Piece. I imagine that they would be pretty accurate and perhaps quicker than a Wiggler (center finder).