rbrading
1st June 2012, 12:35 PM
First post - fingers crossed.
Recently tipped planer on its end to clear out shavings from the dust shute and low and behold a metal block fell out of the shute!
The block is 22mm long, 24mm high and 24 mm deep. It has a 15mm hole throughout and a bevel along the top edges.
Can I get some help please? Suggestions, blueprints etc? Unfortunately the Instruction Manual does not get down to this level of detail.
Recently tipped planer on its end to clear out shavings from the dust shute and low and behold a metal block fell out of the shute!
The block is 22mm long, 24mm high and 24 mm deep. It has a 15mm hole throughout and a bevel along the top edges.
Can I get some help please? Suggestions, blueprints etc? Unfortunately the Instruction Manual does not get down to this level of detail.