tea lady
7th July 2012, 12:49 PM
T-Boy comes with me to work during school hols. This time we decided that he was old enough to learn a bit of turning. We had him roughing down some baltic pine so I can turn them into dibblers. So here's where he got to over two days. Did 21 all up I think. The first one took ages. The last one he did took 3 minutes and 3 seconds. :U and I did one each too. took 23 seconds. I took 25 seconds. :cool: So I guess I'm doing dibblers next week. :doh:
Pic 1 after marking the ends with a center finder he put a little dint in the center with a brad awl to make it easier to locate the head and tail stock.
Pic 2 Load in the lathe.
Pic 3 Turn piece around by hand to make sure the tool rest isn't in the way, and that it is centered properly.
Pic 4 Starting at one end take little bites with the gouge towards the end. Working you way up with each bite. Have the leading hand holding the tool up against the rest to guide you and steady the chisel. The chisel should be perpendicular to the work. Bevel rubbing then raise the back hand till shavings start coming off, then you can move the chisel towards the end off the wood
Pic 5 Continuing up the work The chisel can be turned slightly towards the direction it is traveling. Move your legs not just your arms, other wise the angle of the chisel changes and you have a catch. So take a wider stance with your feet so you can transfer you weight between them as you go along keeping your upper body in the same shape all the way.
Pic 6 When you get near the other end start from that end instead and take little bites again from the other end till you meet in the middle. Take one last smoothing cut along the whole length.
Pic 7 You can check for round by resting the back of the chisel on the work. It makes a clattering sound if there is still flat bits on the wood, and just a smooth sound when it is round.
Pic 8 Turn off the lathe and unwind the tail stock to remove the piece ready for the next one.
Pic 9 Ta daaaaaaaa
Did I forget anything ? :think: Probably. :doh:
Pic 1 after marking the ends with a center finder he put a little dint in the center with a brad awl to make it easier to locate the head and tail stock.
Pic 2 Load in the lathe.
Pic 3 Turn piece around by hand to make sure the tool rest isn't in the way, and that it is centered properly.
Pic 4 Starting at one end take little bites with the gouge towards the end. Working you way up with each bite. Have the leading hand holding the tool up against the rest to guide you and steady the chisel. The chisel should be perpendicular to the work. Bevel rubbing then raise the back hand till shavings start coming off, then you can move the chisel towards the end off the wood
Pic 5 Continuing up the work The chisel can be turned slightly towards the direction it is traveling. Move your legs not just your arms, other wise the angle of the chisel changes and you have a catch. So take a wider stance with your feet so you can transfer you weight between them as you go along keeping your upper body in the same shape all the way.
Pic 6 When you get near the other end start from that end instead and take little bites again from the other end till you meet in the middle. Take one last smoothing cut along the whole length.
Pic 7 You can check for round by resting the back of the chisel on the work. It makes a clattering sound if there is still flat bits on the wood, and just a smooth sound when it is round.
Pic 8 Turn off the lathe and unwind the tail stock to remove the piece ready for the next one.
Pic 9 Ta daaaaaaaa
Did I forget anything ? :think: Probably. :doh: