dhubilant
12th August 2012, 03:29 PM
I have recently coated a table top slab of Jarrah with Glasscoat, when it dried some bubble craters did not flow back and left slightly raised craters, I want to know if I can sand the top back lightly to smooth these craters out then reapply the glasscoat, if so what grit and method isa best for the job at hand?
Cheers Glenn:?
vk4
13th August 2012, 09:41 AM
I would think that 1000# W&D used wet with a cork block , would do the job, then a light rub with 1200#, again wet , .
Then thoroughly clean down the surface , dry it and re-coat.
I qualify my advise in that I have not used Clear Coat , but I believe that it is an Epoxy type coating and this should do what you want.
Jeff
vk4
dhubilant
13th August 2012, 11:33 AM
Thanks Jeff, your advise is much appreciated.
Cheers Glenn.