Lyle
15th August 2012, 08:42 AM
Bought some Egoscope - kalideascope kits. Needed a 13/16 bit to bore out the hole.
Couldn't get one at the WWW show in Syd so was advised that a 20mm was equivalent.
It is too tight a fit for the kit parts and I need to sand out the hole .6mm to allow the correct fit. Not a great amount but enough to be an embuggerance.
I have tried my usual local (Newcastle) supplies, internet and ebay. No luck.
Does anyone know where I can get a 13/16 forstner bit in Aus?
Thanks
Lyle.
Couldn't get one at the WWW show in Syd so was advised that a 20mm was equivalent.
It is too tight a fit for the kit parts and I need to sand out the hole .6mm to allow the correct fit. Not a great amount but enough to be an embuggerance.
I have tried my usual local (Newcastle) supplies, internet and ebay. No luck.
Does anyone know where I can get a 13/16 forstner bit in Aus?
Thanks
Lyle.