IINoddyII
24th March 2013, 11:46 AM
Hola,
finally got around to setting up the thicknesser I brought a few years ago when Triton ceased trading..... (I know right - but I tend to plan ahead.....)
Problem I've got is the the cuttinghead lock is stuck in the lock position.
I can't see how to remove the side of the thicknesser without breaking the tabs holding it in to see where it's jamming.. any ideas?
Thanks in advance.
finally got around to setting up the thicknesser I brought a few years ago when Triton ceased trading..... (I know right - but I tend to plan ahead.....)
Problem I've got is the the cuttinghead lock is stuck in the lock position.
I can't see how to remove the side of the thicknesser without breaking the tabs holding it in to see where it's jamming.. any ideas?
Thanks in advance.