PDA

View Full Version : Round to a Point



wheelinround
24th April 2013, 03:40 PM
A couple of shawl pins and a bracelet all NSW Rosewood care of Greg Ward & Boutique Timbers.

The bracelet and a pin is for Fletty's Elsa's Box.

Oh and the Huon one Fletty supplied the wood.

Sorry about photos

http://2.bp.blogspot.com/-9jI70swG5w0/UXcibonDcRI/AAAAAAAAEVo/n4p9oCK37xQ/s1600/DSCF5834.jpg

http://1.bp.blogspot.com/-odgSnfDFPpk/UXcgZcSb_XI/AAAAAAAAEVI/_U7cJO0hBFE/s1600/DSCF6019.jpg

chuck1
24th April 2013, 09:04 PM
they look great! how long are they?

wheelinround
24th April 2013, 10:08 PM
they look great! how long are they?

Longest is 120mm thinnest is about 7mm for fine shawls they should be even thinner so Sue tells me.
2 I tried to take down further snapped while sitting on the bench 1 Huon but that was wood not me turning them.:roll:

minus459
24th April 2013, 10:27 PM
Ya just keep puttin' the rest of us under rgw hammer Ray:C bloody good stuff :2tsup::2tsup:

undies

wheelinround
24th April 2013, 10:35 PM
Thanks Chuck and Undies ............... :roflmao:

If you had seen what I turned them out of :o I might have a piece left will take photo.

Paul39
25th April 2013, 04:52 AM
Thanks Chuck and Undies ............... :roflmao:

If you had seen what I turned them out of :o I might have a piece left will take photo.

Please do take a photo. I find some of the ugliest pieces picked up along the road make the prettiest turnings.

artme
25th April 2013, 08:03 AM
Nice turning Ray!!!:2tsup::2tsup::2tsup:

Wood Nut
25th April 2013, 11:41 AM
they should be even thinner so Sue tells me.

It's a worry when they don't make the instructions clear enough:;. I suffer the same fate on a fairly regular basis, although, like most males, I still hate reading instruction manuals.

Great job Ray

wheelinround
31st May 2013, 03:44 PM
Please do take a photo. I find some of the ugliest pieces picked up along the road make the prettiest turnings.

Paul sorry this has taken so long I found the last piece yesterday its the better of all the one I turned where the rough bit is the others were even less and rougher. In some cases just enough for the point to make contact.