Router/Jigsaw Table Series 2000 & Workcentre 2000

[GarethR]

Any idea if I can use the two together?

Thanks

[Normanj]

Any idea if I can use the two together?

Thanks

You can. I started off that way, but didn't find it very satisfactory since more often than not I need to switch between tablesaw and router, which can be a pain. I soon decided to buy a separate stand for my router table. As I recall it didn't cost that much.

[GarethR]

I have both and was wondering if the older Router/Jigsaw Table Series 2000 made for the MK3 workcentre could fit and be used with the current Workcentre 2000? The table spans the workcentre but there does not appear to be any included method of attaching the table to the workcentre.