bassmansimon
25th June 2013, 03:39 PM
Here are some Zebrawood Cufflinks I made.
Super simple to do. The cufflink kits come from Timberbits. These are simply cut with a 1/2 inch plug cutter, then sliced on a bandsaw and sanded by hand.
They each have a couple of drops of CA on the top, with micro-mesh to clean up, and then held in place with thick CA.
This could be done to have a flush finish (rather than the surround shaddow on these) by simply turning down some timber to exactly the right diameter on the lathe, then slicing on the bandsaw (or parted off).
Hope you like them.
Simon.
http://oi39.tinypic.com/rtl0s6.jpg
http://oi41.tinypic.com/2nl5qv6.jpg
Super simple to do. The cufflink kits come from Timberbits. These are simply cut with a 1/2 inch plug cutter, then sliced on a bandsaw and sanded by hand.
They each have a couple of drops of CA on the top, with micro-mesh to clean up, and then held in place with thick CA.
This could be done to have a flush finish (rather than the surround shaddow on these) by simply turning down some timber to exactly the right diameter on the lathe, then slicing on the bandsaw (or parted off).
Hope you like them.
Simon.
http://oi39.tinypic.com/rtl0s6.jpg
http://oi41.tinypic.com/2nl5qv6.jpg