PDA

View Full Version : Bosh cc408 alarm



mancity
13th October 2013, 08:26 PM
Hi guys im new to this , my friend has a bosh alarm and zone 5 stays on constantly I isolate the wire at the panel for zone 5 and replaced it with a resistor just in case one of the read switches was faulty but with no luck the number 5 still appeared on keypad Could this a programming issue Thanks for any help

3RU
13th October 2013, 10:25 PM
Hi Mancity,
Not familliar with the Bosch cc408 but if it is a 4 zone unit, could zone 5 be a tamper, cabinet or siren box etc?

3RU

Bob Willson
16th October 2013, 06:20 PM
Could this be the answer?

15. Reset Latching Outputs
This feature only applies if your installer programmed an output to latch (remain on) until you acknowledge the event that occurred.
How To Reset Latching Outputs
Hold down the [7] key until two beeps sound. The output resets.