jarradds123
26th October 2013, 10:06 PM
Hi All,
I made my first pepper mills today out of Jacaranda and Blackwood I got from MM, they are 10 Inches high. It is a lot easier making an individual item and not trying to match them. The photo is from my phone so it is not the best.
I am hoping you could let me know what you normally finish your mills with? At this stage I have only sanded to 500g and EEE. I was going to use Shellawax however this is only going to protect the outside. Would Rustins DO be suitable? At this stage I am unable to look at a system for spraying NC lacquer. I am after a finish for the lathe or one that can easily be applied after turning.
Thanks in advance.
Cheers290940
I made my first pepper mills today out of Jacaranda and Blackwood I got from MM, they are 10 Inches high. It is a lot easier making an individual item and not trying to match them. The photo is from my phone so it is not the best.
I am hoping you could let me know what you normally finish your mills with? At this stage I have only sanded to 500g and EEE. I was going to use Shellawax however this is only going to protect the outside. Would Rustins DO be suitable? At this stage I am unable to look at a system for spraying NC lacquer. I am after a finish for the lathe or one that can easily be applied after turning.
Thanks in advance.
Cheers290940