SHIPPERS
11th November 2013, 01:37 PM
I was wondering whether any of you out there might be interested in helping me out.
I have a workbench project on the go and as part of the project i need/want to make a couple of vises using wooden bolts. I have tried to make the blanks using a router jig i made but the finish isnt up to scratch. For the purposes of discussion the blanks are to be in the area of 50 -60mm diameter by 600 long. Tallowwood to be laminated to create the blank.
I am located in Melbournes north west.
If anyone is interested send me a reply
Regards
SHippers:roll:
I have a workbench project on the go and as part of the project i need/want to make a couple of vises using wooden bolts. I have tried to make the blanks using a router jig i made but the finish isnt up to scratch. For the purposes of discussion the blanks are to be in the area of 50 -60mm diameter by 600 long. Tallowwood to be laminated to create the blank.
I am located in Melbournes north west.
If anyone is interested send me a reply
Regards
SHippers:roll: