Jafo :)

[MickR]

G'day all, My name's Mick. I'm reasonably new to all this turning stuff and to date haven't done much more than a shaving brush in a bit of off cut timber just to see if I could, and a few fipple blocks for whistles made out of electrical conduit. The blocks were turned down to size from a length of Delrin rod. So as you see I don't have a great deal of experience, and now I find myself in woes with my old lathe, which is the reason why I came here in the first place. I need help sourcing a part for my lathe. Where should I post these sort of questions? Thanks for any help you can provide.


Mick

[old1955]

Welcome to the forum Mick.

[tdrumnut]

Gidday & welcome aboard Mick, may your journey with us be a pleasant one.

[MickR]

Thanks for the welcome Gents. I've been looking around for a section here to post up my lathe problem, to seek out help, but I'm not sure where I should post it. So I think the small machinery section might be the best area. I'll try there anyway. Thanks again for the welcome.


Mick

[JJF]

Welcome to the forum

[crowie]

G'Day & Welcome to a top forum "Mick".
There are quite a few members in and around Brisbane & SE Queensland.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork..
Cheers crowie

PS - It's best to ask the specific question in a number of sub-section to great a wider audience...
GENERAL & SMALL MACHINERY (http://www.woodworkforums.com/f155/)
WOODWORK - GENERAL (http://www.woodworkforums.com/f11/)
HAND TOOLS - POWERED (http://www.woodworkforums.com/f13/)
WOODWORK - GENERAL (http://www.woodworkforums.com/f11/)
WOODTURNING - GENERAL (http://www.woodworkforums.com/f8/)

[MickR]

G'Day & Welcome to a top forum "Mick".
There are quite a few members in and around Brisbane & SE Queensland.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork..
Cheers crowie

PS - It's best to ask the specific question in a number of sub-section to great a wider audience...
GENERAL & SMALL MACHINERY (http://www.woodworkforums.com/f155/)
WOODWORK - GENERAL (http://www.woodworkforums.com/f11/)
HAND TOOLS - POWERED (http://www.woodworkforums.com/f13/)
WOODWORK - GENERAL (http://www.woodworkforums.com/f11/)
WOODTURNING - GENERAL (http://www.woodworkforums.com/f8/)


Thanks mate. Seems that it doesn't want me to make the post I need to make with photo's. I'm having no end of technical glitches with he forum. Probably user error, but a pain in the behind none the less.
What I need to find out is where to get a replacement rear bearing for Remag WL 800. Any ideas?


Mick