Dave J
19th December 2013, 06:51 PM
Hi
Just going through some pictures on photo bucket and found the finished photos of the arbour support i posted here some time back, but the thread wont allow me to reply with the glitch we have.
It is a continuation of this thread
http://www.woodworkforums.com/f65/hm-52-horizontal-arbor-support-clean-up-121464/
I had to bore out the support on one side and make up a threaded bush to straiten the clamping rod up.
I straitened up the cut vertical by just widening it by the minimum.
While I was there I added a oiling barbed which I have fitted a drip feeder to up on the ram.
I was able to use the grub screw hole in the bottom to gain access to drill the hole for the barb. As I have stated before my mill is s HM52B and one of the differences is the arbour support hss no center web where the barb is.
http://img.tapatalk.com/d/13/12/19/3yse9a5y.jpg
http://img.tapatalk.com/d/13/12/19/yparyjyt.jpg
http://img.tapatalk.com/d/13/12/19/du5e2aby.jpg
Dave
Just going through some pictures on photo bucket and found the finished photos of the arbour support i posted here some time back, but the thread wont allow me to reply with the glitch we have.
It is a continuation of this thread
http://www.woodworkforums.com/f65/hm-52-horizontal-arbor-support-clean-up-121464/
I had to bore out the support on one side and make up a threaded bush to straiten the clamping rod up.
I straitened up the cut vertical by just widening it by the minimum.
While I was there I added a oiling barbed which I have fitted a drip feeder to up on the ram.
I was able to use the grub screw hole in the bottom to gain access to drill the hole for the barb. As I have stated before my mill is s HM52B and one of the differences is the arbour support hss no center web where the barb is.
http://img.tapatalk.com/d/13/12/19/3yse9a5y.jpg
http://img.tapatalk.com/d/13/12/19/yparyjyt.jpg
http://img.tapatalk.com/d/13/12/19/du5e2aby.jpg
Dave