PDA

View Full Version : Some might call it failure



DaveTTC
2nd April 2014, 05:59 PM
Ah I call it experience. So inspired by smiife and his twisted candle stick holders I thought (as I often do) 'these things can't take that long'

On that note I had never done one before I marked one out.

The first one took me about 4 hours and by no means finished. These two .... Make that one and a half took me all day.

http://img.tapatalk.com/d/14/04/02/y8u5ysa5.jpg

I thought I'd get apart and mark out a matching pair on a single blank. Then I tried to trim the blank square after I made the too spiral on my drop saw with a blunt blade.

To add to my stupidity I thought I would put a router bit in my drill press and try and hand feed the bottom section. I had a guide either side so it was just a case of push and twist.

http://img.tapatalk.com/d/14/04/02/u6y2aba6.jpg

It works brilliant in principle.

Oh well such is life.

I call the top piece DNA.

While I has my guide set up I thought I'd swap over to v bit and engrave a message to my wife.

Back to te drawing board


Dave the turning cowboy

turning wood into art