woodman12
27th April 2014, 12:23 PM
wooden face plates made 3 in and 4 in diameter , I used cherry
bored and threaded to fit the lathe
These should last a long time at least it will not damage your lathe tools
Any size can be made but its the wood blank required that can drive the cost up
as you need about 1.5 thick wood
http://youtu.be/p9eH2JXt8vI
bored and threaded to fit the lathe
These should last a long time at least it will not damage your lathe tools
Any size can be made but its the wood blank required that can drive the cost up
as you need about 1.5 thick wood
http://youtu.be/p9eH2JXt8vI