Strange order

[chuck1]

I had to turn a single table leg using a post pattern but make like a table leg at the bottom! So 4 of them, no just 1!
Only one safety note tighten the tailstock fully to the bed of lathe! Wondered why I had vibration! I guess thats what happens when I am interrupted mid job!
Thanks for looking!

[Christos]

Makes sense to me. Only one was broken or lost in the move between houses. :U

[smiife]

Hi chuckie,
Looks good mate, ..er one legged table:no:
Hope you had the coldies after you finished
the job and not before:U

[chuck1]

Only half a can of coke no alcohol additives! I think because is was setting up for balusters on the boss came out and needed the leg asap so I left the lathe to get timber and cut it the same length as the bals so I only had to move the toolrest, I'm checking it every 5 or 6 bals now as the lathe is spinning at 1800 rpm.