artme
15th May 2014, 12:43 PM
I have a SN2 Chuck and want to know if there are jaws to fit that will solve the following problem:
Most of my turning has been small stuphph and any larger turning, such as bowls, has been done with the chuck in expansion mode in a recess in the bottom of the bowl.
However, I started some pieces at the club before I left Bris. and these were done with spigots using the jaws
in compression mode.
The spigots are between about 88mm and 96 mm. Is there a set of jaws that will do the job of holding these pieces and also fit my SN2 chuck???
Most of my turning has been small stuphph and any larger turning, such as bowls, has been done with the chuck in expansion mode in a recess in the bottom of the bowl.
However, I started some pieces at the club before I left Bris. and these were done with spigots using the jaws
in compression mode.
The spigots are between about 88mm and 96 mm. Is there a set of jaws that will do the job of holding these pieces and also fit my SN2 chuck???