Suitable Chuck Jaws

[artme]

I have A SN2 chuck and a small Teknatool tommy bar chuck.

I also have a couple of sets of bowl jaws, a set of pin jaws and a set of 35mm spigot jaws
acquired at the recent Bris. WWW show.

I went to the show with the intention of buying both the 35mm jaws and a set of Powergrip
jaws., You see, I have a number of projects started before I left Bris., and therefore the club.
These projects were started using larger jaws of the Powergrip type.

No one had the Powergrip jaws and I thought of getting a set of VM jaws and boring out the holes
so they matched the SN chuck holes.

Enzo informed me that just drilling out the holes was a no no. He said the only way to do it was
for him to take my chuck and the VM jaws and have everything properly aligned and machined.

I think, given his background and experience, that he should be believed.

I am going to have a look at US sites to see if I can pick up the set I want.

Any comments that may be helpful would be appreciated.

[smiife]

Hi artme,
If you cannot get them in australia, terry scott
has them on his web site......www.timberlywoodturning.co.nz
approx. $75.00 nz.....hope this helps

[NCPaladin]

If they don't have them in stock they should be able to order them for you. At least that is what Teknatool says..
http://www.teknatool.com/distributors/australia.htm

[Pat]

If you cannot get them here, try Amazon.
(http://www.amazon.com/NOVA-PJSN-PowerGrip-Chuck-Accessory/dp/B0064JJCZA)

[artme]

Thanks fellas.

I have sent an email to Timberly in NZ. Waiting for a reply.

Will try Amazon also.

[chuck1]

Carbatec have not got any? I found ringing them was better than going in store! I wouldn't be keen on drilling them out as I was thinking of doing the same thing until I saw the difference in hole centres!