Universal Baseplate - Free

[Normanj]

I have an unused "Universal" baseplate (doesn't fit a Triton TRA-001 so it isn't that universal).

http://www.carbatec.com.au/universal-router-base-plate_c19385

It's new and unused, complete with screws and centering pin. I'm happy to give it to someone in return for the postage costs

[Sir Stinkalot]

Hi Norman,

If nobody more worthy comes forward I would be interested. I have a little Makita router I would be keen to try it out on.

Cheers

Stinky

[Normanj]

Hi Norman,

If nobody more worthy comes forward I would be interested. I have a little Makita router I would be keen to try it out on.

Cheers

Stinky

This is the best offer I've had so far. Send me a PM with your address and I'll get it in the post some time next week.

The instructions that come with it says it fits "most" Makita routers.

[Sir Stinkalot]

Sounds good to me ...... if it doesn't suit my router I will put forward the same offer for the next person.
PM on the way.

Cheers

Stinky

[jw2170]

I have one and it does fit my 3612C and 3600,

You use the two holes near the centre that the guide bushing screws on to....

I have mine set up for the Makita's, Ryobi and Ozito routers.

I am next in line if you do not want it.....VBG.

[Sir Stinkalot]

Hi Norman,

The router plate arrived last night thank you ...... not a mark on it. I have just headed down to the garage and found that it does fit on the Makita 3620 which is a relief. As per jw2170's post it is secured by the two holes near the centre (for anybody else looking at purchasing one).

I just need to now find the brass template follower (which I am sure that a came across the other day as I remember thinking that it was an expensive purchase that I wasn't able to get the best use out of) before I can fit the base permanently.

Thank you again for your kind offer. Please PM me you bank details and I will transfer some money to cover postage, or alternatively I can send a cheque to the return address on the package if you prefer.

Looking forward to testing out the template follower now.

Cheers

Stinky.