Graham Sands
8th July 2005, 05:10 PM
I am contemplating buying a drill press and would appreciate some recommendation and advice.
I really only want a small one, however, the small ones I have looked at are not very good. Currently I’m thinking about the Carba-Tec CH16N?
It would be handy to use down to 1/16” bits.
Any thoughts?
I really only want a small one, however, the small ones I have looked at are not very good. Currently I’m thinking about the Carba-Tec CH16N?
It would be handy to use down to 1/16” bits.
Any thoughts?