Aussie Holden
21st February 2015, 05:13 PM
I have recently purchased a 6040 800w water cooled cnc router off ebay. I have set it all up following the very sketchy instructions and have tested it and I was very happy with the results. The next time I went to use it I have accidently pressed one of the buttons on the VFD Inverter and have somehow changed all of the settings so now when I push the green run button the spindle does not start . If I press the set button the led displays pn01 and if I keep scrolling through it goes up to pn35. The instruction manual tells me no more than how to adjust the spindle speed using the speed control knob. I have tried looking on the internet for a manual but because there is no brand name on the VFD I haven't had much luck The VFD is 220V 1.5KW Spindle is 800W 220V 400HZ 24000RPM water cooledI have also attached a photo of the VFD I hope someone can help me with this little problem as I am looking forward to using my cnc router again.