tore
16th May 2015, 06:12 PM
Hi
Just got this Hyco lathe, it is complete with motor but no bench to mount it on
Bearings seems to be ok span it up using electric drill and no noises was coming from them, seems to have been replaced as
the bearings are are using rubber seals so must be newer than the lathe. The big banjo was not with the lathe, I made that
one up for my other lathe and only transfered it to the Hyco as the other is going to be sold. It is a carbatec 1100A
347304
Just got this Hyco lathe, it is complete with motor but no bench to mount it on
Bearings seems to be ok span it up using electric drill and no noises was coming from them, seems to have been replaced as
the bearings are are using rubber seals so must be newer than the lathe. The big banjo was not with the lathe, I made that
one up for my other lathe and only transfered it to the Hyco as the other is going to be sold. It is a carbatec 1100A
347304